PipelineFX Forum
Qube! => Installation and Configuration => Topic started by: danprice on September 13, 2008, 01:27:34 AM
-
I setup a job to send email upon completion but I don't receive the email message and I don't see any warnings or errors about why the email might have failed to send. Is there something I need to do, to configure it to send email or where should I check for problems.
-
Have you had a look at the supelog to see if there were any error messages logged when it attempted to send the mail?
-
I checked the log and I just see this failure ERROR: unable to send mail to user: danprice@microsoft.com via: smtphost.dns.microsoft.com.
I was looking in the administration.pdf file and it says "This will work with
any server which has mail relaying enabled or is the destination email server." I know that our SMTP server requires authentication. Will qube authenticate as the user the service is running under, or can I specify credentials in the config file.