PipelineFX Forum
Qube! => Installation and Configuration => Topic started by: Achilles on May 03, 2010, 03:29:46 PM
-
hi
the admin manual says that "remove_logs" is the included as default in supervisor_flags.
but if I do a "qbremove zzz" the logs are still there on the supervisor.
- Thomas
-
hmm... what version of Qube is running on your supervisor? It may no longer be the default behavior.
Can you run 'qbadmin s --config', and post the line that contains "supervisor_flags"? It will be set to an integer, but I can look it up against the bitmask and will tell you what it translates to.
-
hmm.. after strange things happend i moved the supervisor from Mac OS X10.5 to a Centos 5.4 host.
On OS X in /var/log/supelog no supervisor messages except "permission granted to user [xyz]" were logged. then after a while the supervisor would not distribute the work anymore to all the nodes. On the pipelinefx homepage i'm reading that 10.5 should be supported - so I'm a bit puzzled. What version of qube is needed for OS X 10.5 - the 10.3 or the 10.6 package?
After moving the supervisor to CentOS 5.4 i can see the following startup messaegs (and the other loglines too):
supervisor_flags: host_recontact,heartbeat_monitor,running_monitor,stub_optimize,retry_busy (7174)
so, it seems the docs should be updated to reflect the new defaults.
- Thomas