Author Topic: Blocking from GUI crashes Supervisor  (Read 4869 times)

pboucher

  • VFX Geek
  • Full Member
  • ***
  • Posts: 24
    • XSIBlog
Blocking from GUI crashes Supervisor
« on: December 17, 2007, 10:23:21 PM »
QubeGui 5.2.3
QubeSupervisor 5.2.2
All systems are Windows XP

Trying to block a job that has running subjobs crashes the supervisor.

Can anybody repro this?

Scot Brew

  • Hero Member
  • *****
  • Posts: 272
    • PipelineFX
Re: Blocking from GUI crashes Supervisor
« Reply #1 on: December 17, 2007, 10:40:39 PM »
We will check into this on our side and get back to you.

Regards,
Scot

Scot Brew

  • Hero Member
  • *****
  • Posts: 272
    • PipelineFX
Re: Blocking from GUI crashes Supervisor
« Reply #2 on: December 21, 2007, 06:22:45 AM »
We were unable to reproduce the issue you are describing.  It is likely that there may be something else going on with your environment and setup.

We tested with the following workflow:
1) Run a simple 'ping' cmdrange job
2) Block the job while it has a running subjob
3) Unblock the job
Result: Job completed fine.

Send us an email at support@pipelinefx.com and we can dig a bit deeper into what is happening for you.

Regards,
Scot